Remote BT-1 – SmallHD – Technical – How do I use my remote on my monitor
How do I connect the remote? What monitors does does this work with? Can I power it on and off with the remote?
The BT-1 Remote will work with any of our monitors that are not Legacy Products:
To connect the remote, go to the menus under remote and be sure its enabled. Hold the blue joystick down for about 5 seconds, you should see the Remote link under the status column. Select it on the monitor and it will “bind”. Once this is tied (Active), it will work as a normal joystick would. It will blink blue light slowly when paired. It will blink fast blue when not paired. If pairng fails, try power cycling the monitor.
Selecting an “active” remote in the menu setting will give a few options for Joystik Orientation
If the remote is blinking red and blue quickly, you will need to replace the batteries. It takes 2x CR1620 watch style batteries.
The remote has Four buttons:
Joystick, which can be clicked to select and moves up, down, left and right. This will act the same as the joystick on the monitor or your touch interactions on a touch screen.
There is a back or close button [ < ].
There is an Image Capture button [ o ]. This allows you to use the image capture function, this will work without the tool being active. It will work like
The power Button (Located on top of the remote above the Joystick). You can power off the monitor using the remote and also power it back on. There is a caveat to powering it back on though, you cant power on the monitor using the remote after a hard power cycle(removing the battery/ power source).
The remote can only be paired one Monitor at a time, but you can multiple remotes with one monitor (up to 3).
You will need to “unpair” a remote to have it work on another monitor. This is done through the Menu Settings. Have both the remote on and the Monitor on. Select “active” and choose “unbind”.
If for some reason the remote is acting incorrectly, you can do a reset by holding the image capture button down until the Red light goes off.
remote, pair, pairing, button, bt1