SHD Support - Firmware All Wireless Monitors – SmallHD – Technical – Which Frequencies to Select Region

All Bolt Monitors – SmallHD – Technical – Which Region to Select

PROBLEM

Which region setting should I choose on my Bolt monitor in the US?

SOLUTION

If you're pairing the monitor with other Teradek Bolt products you'll want to select US FCC on the monitor; that is the equivalent for the USA setting on the Teradek products. If you're only using SmallHD monitors with each other (such as a Focus Bolt TX with a Focus Bolt RX), the US Indoor setting gives more channels to work with, but not all of the Teradek products can work with that setting. The engineers are working on unifying those choices in the future to simplify things.

This was changed in firmware later than 3.5+ to be region specific (i.e. USA, UK, JAPAN etc).

Keywords

Focus Bolt, Focus Bolt TX, Focus Bolt RX, Focus Bolt 500 TX, Focus Bolt 500 RX, Focus Bolt Sidekick RX, 703 Bolt, 703, Teradek, Teradek Bolt, Teradek Bolt 500 XT, Teradek Bolt 500 LT, Bolt 500, Teradek Bolt 1000 XT, Teradek Bolt 1000 LT, Bolt 1000, Teradek Bolt 3000 XT, Bolt 3000, Bolt

Problems pairing, pairing error, failed, wireless, signal

CASE: